113.4 g metal magic glue stick Huaihua City Loctite 98853 the metal magic glue stick, loctite98853, Loctite Metal magic glue stick 98853 Pressure Seal steel bar rod filled steel powder epoxy glue, kneading by hand to fill in the gap or The holes can be plugging the applicable time of 3 minutes, fixture time of 10 minutes. Cured, can be drilled, tapped, painted paint. Apply to emergency water tanks and pipes leaked sealed patches, can be used in the iron and steel material pressure lower than 0.3MPa conditions plugging. Fill level; weld to repair a small crack on the casting. Too large a bolt hole to be filled. The products conform NSF61 standard. It is a steel reinforced Putty, be filled with the adhesive may be a metal material such as steel, iron, aluminum, container, pipes, and some parts of the drain hole, cracks, blisters, defects, fracture, damage etc.. In addition, it can quickly create and copy the parts, model, model repair spalled threaded bolt sturdy fixed, seals and a variety of other forms of mounting. Mainly used for the repair of cast iron and stainless steel parts, repair casting defects, fill cracks, holes. Produce nuts, screws, thread repair worn; for metal equipment, tools, pipes, appliances and auto body repair; does not shrink after curing, never rust; cured color gray metallic luster. Before use, to be patched at around floating rust, dust, grease and other floating objects shall clean up. Remove the plastic tube in the colloid, and cut to the desired dosage, the colloid within the core and sheath material of two different colors by hand to fully blend into the color (about 1 to 2 minutes) until homogeneous. Its hard compacted cement to repair at and try to squeeze into the holes and cracks. After mixing the binder will soon colloidal reaction, after 3 to 5 minutes a slight fever ,10-20 minutes after both very hard cured. Cured before the clay-like form of its use, not dripping, not flowing, very convenient to use. Winter cold areas should colloids and the surface to be repaired properly heated to room temperature or slightly above. Technical parameters: color: dark gray shear strength: ≥ 3.45LMS Withstand shear strength (N / mm ^ 2) ISO 10123: steel pin and ring: 82.7 Tensile strength: 17.2 maximum temperature: 121 (℃) curing time : 10 content: 4oz coating area (cm ^ 2/6mm thick / tube): 45 aluminum Order Loctite glue (N / mm ^ 2) (acid etching) 0.125mm gap: 4.8 Welcome to inquire, we will be happy to your service!! Hotline 0769 -8535-7789 Sales Hotline :0189-2826-8345 QQ online :190-2710-234 Company E-mail: zhu750120@163.com: www.loctite596.com