Zhongshan Loctite 569 thread glue, Henkel 569 metal pipe nipple guide seal of Loctite 569 hydraulic and pneumatic systems. Not pollute the hydraulic system, may also be used in a slight grease surface. Fast curing, low strength. It no filler does not clog the valve or filtration system. For sealing and locking (with conical nipple) high-pressure hydraulic power system, M36 taper thread (NPT). Sealing of hydraulic / pneumatic systems. LOCTITE? 569? Pipe thread contact for locking and sealing of plastic and metal. Curing the cut off oxygen to metal sealing surface to prevent loosening due to vibration or shock or leakage. Use guide assembly in order to obtain the best results, such as Loctite ODC free cleaner the thorough cleaning solvent, and dried. 2 If the material is inert metal or the cure speed is too slow, the use of a catalyst 7471? 7649? and dry . products of applying a lap in the front end of the male thread thread Do coating applied first section thread. On the threads to thoroughly fill the voids. For larger threads and voids, adjust product amount accordingly and at the same time the inner threads of applying lap products. 4. Use of acceptable experience to install and tighten the fittings until the assembly in place. 5. Fully assembled connection instant sealing member has a certain capacity, in order to ensure that has a maximum pressure resistance and solvent resistance, it is necessary to ensure that the sealant is cured at least 24 hours to ensure that the cured completely. REMOVAL 1. using standard removal tool disassembly. 2. cured product can be produced by Loctite solvent infiltration and mechanical scraping (such as a wire brush) a combination of methods to get rid of. welcome to inquire order Loctite glue, we will be happy to serve you!! Hotline :0769 -8535-7789 Sales Hotline :0189-2826 -8345 QQ the online 190 -2710-234 Company E-mail: zhu750120@163.com: www.loctite596.com